i m trying to do VLAN mode. below is the previous config that I tried,
nieg@LAB-MX-PE5# show interfaces ge-1/1/0.601 encapsulation vlan-ccc; vlan-id 601 input-vlan-map pop; output-vlan-map push; [edit] nieg@LAB-MX-PE5# show protocols l2circuit neighbor 10.20.0.2 { interface ge-1/1/0.601 { virtual-circuit-id 6012; } } Cisco side: interface GigabitEthernet0/1.610 encapsulation dot1Q 610 xconnect 10.20.0.5 6012 encapsulation mpls end even tried as per the config you asked for but still the same result, VC stays up but no data flowing nieg@LAB-MX-PE5# run show l2circuit connections extensive Neighbor: 10.20.0.2 Interface Type St Time last up # Up trans ge-1/1/0.601(vc 6012) rmt Up Nov 1 17:50:20 2012 1 Remote PE: 10.20.0.2, Negotiated control-word: Yes (Null) Incoming label: 299792, Outgoing label: 40 Negotiated PW status TLV: No Local interface: ge-1/1/0.601, Status: Up, Encapsulation: VLAN Connection History: Nov 1 17:50:20 2012 status update timer Nov 1 17:50:20 2012 PE route changed Nov 1 17:50:20 2012 Out lbl Update 40 Nov 1 17:50:20 2012 In lbl Update 299792 Nov 1 17:50:20 2012 loc intf up ge-1/1/0.601 _______________________________________________ juniper-nsp mailing list juniper-nsp@puck.nether.net https://puck.nether.net/mailman/listinfo/juniper-nsp