I agree it is not quite the same. The hierarchical FIB and next-hop indirection so the number of prefixes is independent of the reconvergence time has been in Junos for a long time. That is like the PIC part.
Junos would rather you use BGP add-path for the ingress PE side to support multiple egress PEs with faster protection. I suppose you could also use add path for CE protection, or this feature. I don't think the config guide is particularly good with regards to this feature. Phil From: Jesper Skriver Sent: 1/1/2013 5:40 To: Phil Bedard Cc: Robert Hass; juniper-nsp@puck.nether.net Subject: Re: [j-nsp] BGP PIC Edge on MX platforms Disclaimer, I work for cisco and was involved in the idea, design and implementation of BGP PIC Edge, though here I speak only for myself and not my employer. >From the "Example: Configuring MPLS Egress Protection for Layer 3 VPN Services" of http://www.juniper.net/techpubs/en_US/junos12.2/information-products/topic-collections/config-guide-vpns/config-guide-vpns.pdf It looks like this is a very different thing than BGP PIC Edge, it require manual configuration and designated PLRs. None of that is required with BGP PIC Edge, which on a per prefix basis will on the ingreess PEs automatically calculate the primary and repair egress PE, and setup forwarding structures allowing Prefix Independent (constant time) Convergence of all affected prefixes when the loopback of the primary egress PE is withdrawn from the IGP. Additionally BGP PIC Edge also provides Prefix Independent Convergence in the case of a PE-CE link failure, or CE node failure, where the egress PE will redirect traffic to an backup PE/CE, again the backup PE/CE is automatically pre-calculated on a per prefix basis, so you can have CE1 be the primary for say 10k prefixes, where CE2 is the backup for 5k of them and CE3 for the remaining 5k. Lastly, this all works for prefixes in a L3 VPN or in the global routing table, as long as the IGP routes are labeled. /Jesper On Tue, Jan 01, 2013 at 12:04:15AM -0500, Phil Bedard wrote: > 11.4R3 I believe. Juniper calls it MPLS Egress Protection for L3VPN > > Phil > > On Dec 31, 2012, at 7:34 PM, Robert Hass <robh...@gmail.com> wrote: > > > Hi > > Is BGP PIC Edge functionality supported on current MX platforms ? (eg. > > JunOS 11.4R6 or 12.x) > > > > Rob > > _______________________________________________ > > juniper-nsp mailing list juniper-nsp@puck.nether.net > > https://puck.nether.net/mailman/listinfo/juniper-nsp > _______________________________________________ > juniper-nsp mailing list juniper-nsp@puck.nether.net > https://puck.nether.net/mailman/listinfo/juniper-nsp /Jesper -- Jesper Skriver, jesper(at)skriver(dot)dk - CCIE #5456 One Unix to rule them all, One Resolver to find them, One IP to bring them all and in the zone to bind them. _______________________________________________ juniper-nsp mailing list juniper-nsp@puck.nether.net https://puck.nether.net/mailman/listinfo/juniper-nsp