* Sebastian Wiesinger <juniper-...@ml.karotte.org> [2013-02-14 08:06]: > * Stacy W. Smith <st...@acm.org> [2013-02-12 01:18]: > > > Do the KRT error messages go away if you unconfigure sampling? Any > > change in the KRT installation time with sampling turned off? > > I'll test that. I assume I will need to completely disable the > sampling instance?
So, I just tested this after talking to JTAC. Just for reference: I had ~70k routes from 40 peers that I deactivated. I then turned them up again and measured with inline-jflow disabled and enabled. With inline-jflow ON: around 10-12 minutes until KRT settles With inline-jflow OFF: around 2 minutes until KRT settles To build a full table (after reboot) it's even longer of course. This produces very nice loops while it's settling. I can disable inline-jflow when doing upgrades/planned maintenance but I need it the rest of the time. So... out of luck for unplanned BGP session resets. I'm waiting for JTAC on how to proceed. Regards Sebastian -- GPG Key: 0x93A0B9CE (F4F6 B1A3 866B 26E9 450A 9D82 58A2 D94A 93A0 B9CE) 'Are you Death?' ... IT'S THE SCYTHE, ISN'T IT? PEOPLE ALWAYS NOTICE THE SCYTHE. -- Terry Pratchett, The Fifth Elephant _______________________________________________ juniper-nsp mailing list juniper-nsp@puck.nether.net https://puck.nether.net/mailman/listinfo/juniper-nsp