The memory allocated by VIR_REALLOC_N() is uninitialized,
which means it's not possible to figure out whether any
output was produced at all after the fact.
Since we don't care about the previous contents of buffers,
if any, use VIR_FREE() followed by VIR_ALLOC_N() instead.
Signed-off-by: Andrea Bolognani <abolo...@redhat.com>
---
src/util/vircommand.c | 6 ++++--
1 file changed, 4 insertions(+), 2 deletions(-)
diff --git a/src/util/vircommand.c b/src/util/vircommand.c
index d965068369..3d533c68a6 100644
--- a/src/util/vircommand.c
+++ b/src/util/vircommand.c
@@ -2055,12 +2055,14 @@ virCommandProcessIO(virCommandPtr cmd)
* results accumulated over a prior run of the same command. */
if (cmd->outbuf) {
outfd = cmd->outfd;
- if (VIR_REALLOC_N(*cmd->outbuf, 1) < 0)
+ VIR_FREE(*cmd->outbuf);
+ if (VIR_ALLOC_N(*cmd->outbuf, 1) < 0)
ret = -1;
}
if (cmd->errbuf) {
errfd = cmd->errfd;
- if (VIR_REALLOC_N(*cmd->errbuf, 1) < 0)
+ VIR_FREE(*cmd->errbuf);
+ if (VIR_ALLOC_N(*cmd->errbuf, 1) < 0)
ret = -1;
}
if (ret == -1)
--
2.20.1
--
libvir-list mailing list
libvir-list@redhat.com
https://www.redhat.com/mailman/listinfo/libvir-list
