On Thu, Jan 17, 2013 at 12:32:48PM +0200, Felipe Balbi wrote:
> Hi,
>
> On Thu, Jan 17, 2013 at 12:31:05PM +0200, Mika Westerberg wrote:
> > If IC_EMPTYFIFO_HOLD_MASTER_EN is set to one, the DesignWare I2C controller
> > doesn't generate STOP on the bus when the FIFO is empty. This violates the
> > rules of Linux I2C stack as it requires that the STOP is issued once the
> > i2c_transfer() is finished.
> >
> > However, there is no way to detect this from the hardware registers, so we
> > must make sure that the STOP bit is always set once the last byte of the
> > last message is transferred.
> >
> > This patch is based on the work of Dirk Brandewie.
> >
> > Signed-off-by: Mika Westerberg <mika.westerb...@linux.intel.com>
> > ---
> > drivers/i2c/busses/i2c-designware-core.c | 16 ++++++++++++++--
> > 1 file changed, 14 insertions(+), 2 deletions(-)
> >
> > diff --git a/drivers/i2c/busses/i2c-designware-core.c
> > b/drivers/i2c/busses/i2c-designware-core.c
> > index f5258c2..94fd818 100644
> > --- a/drivers/i2c/busses/i2c-designware-core.c
> > +++ b/drivers/i2c/busses/i2c-designware-core.c
> > @@ -413,11 +413,23 @@ i2c_dw_xfer_msg(struct dw_i2c_dev *dev)
> > rx_limit = dev->rx_fifo_depth - dw_readl(dev, DW_IC_RXFLR);
> >
> > while (buf_len > 0 && tx_limit > 0 && rx_limit > 0) {
> > + u32 cmd = 0;
> > +
> > + /*
> > + * If IC_EMPTYFIFO_HOLD_MASTER_EN is set we must
> > + * manually set the stop bit. However, it cannot be
> > + * detected from the registers so we set it always
> > + * when writing/reading the last byte.
> > + */
> > + if (dev->msg_write_idx == dev->msgs_num - 1 &&
> > + buf_len == 1)
> > + cmd |= BIT(9);
> > +
> > if (msgs[dev->msg_write_idx].flags & I2C_M_RD) {
> > - dw_writel(dev, 0x100, DW_IC_DATA_CMD);
> > + dw_writel(dev, cmd | 0x100, DW_IC_DATA_CMD);
> > rx_limit--;
> > } else
> > - dw_writel(dev, *buf++, DW_IC_DATA_CMD);
> > + dw_writel(dev, cmd | *buf++, DW_IC_DATA_CMD);
>
> also need to send STP bit if I2C_M_STOP is set.
True but only if the driver exposes I2C_FUNC_PROTOCOL_MANGLING, which is
not done in this driver.
--
To unsubscribe from this list: send the line "unsubscribe linux-i2c" in
the body of a message to majord...@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
