Linux version 2.4.28-gateway (root@gzp1) (gcc version 3.4.3) #1 Sat Jan 8 14:15:59 CET 2005
BIOS-provided physical RAM map:
 BIOS-e820: 0000000000000000 - 00000000000a0000 (usable)
 BIOS-e820: 00000000000f0000 - 0000000000100000 (reserved)
 BIOS-e820: 0000000000100000 - 0000000003dfc000 (usable)
 BIOS-e820: 0000000003dfc000 - 0000000003dff000 (ACPI data)
 BIOS-e820: 0000000003dff000 - 0000000003e00000 (ACPI NVS)
 BIOS-e820: 00000000fff80000 - 0000000100000000 (reserved)
61MB LOWMEM available.
On node 0 totalpages: 15868
zone(0): 4096 pages.
zone(1): 11772 pages.
zone(2): 0 pages.
Kernel command line: auto BOOT_IMAGE=Linux ro root=301 hdc=noprobe hdd=noprobe
ide_setup: hdc=noprobe
ide_setup: hdd=noprobe
Initializing CPU#0
Detected 601.368 MHz processor.
Console: colour VGA+ 80x25
Calibrating delay loop... 1199.30 BogoMIPS
Memory: 60800k/63472k available (1003k kernel code, 2288k reserved, 206k data, 72k init, 0k highmem)
Dentry cache hash table entries: 8192 (order: 4, 65536 bytes)
Inode cache hash table entries: 4096 (order: 3, 32768 bytes)
Mount cache hash table entries: 512 (order: 0, 4096 bytes)
Buffer cache hash table entries: 1024 (order: 0, 4096 bytes)
Page-cache hash table entries: 16384 (order: 4, 65536 bytes)
CPU: L1 I cache: 16K, L1 D cache: 16K
CPU: L2 cache: 128K
CPU:     After generic, caps: 0383f9ff 00000000 00000000 00000000
CPU:             Common caps: 0383f9ff 00000000 00000000 00000000
CPU: Intel Celeron (Coppermine) stepping 03
Enabling fast FPU save and restore... done.
Enabling unmasked SIMD FPU exception support... done.
Checking 'hlt' instruction... OK.
POSIX conformance testing by UNIFIX
PCI: PCI BIOS revision 2.10 entry at 0xf0eb0, last bus=1
PCI: Using configuration type 1
PCI: Probing PCI hardware
PCI: Probing PCI hardware (bus 00)
PCI: Using IRQ router SIS5595 [1039/0008] at 00:01.0
Linux NET4.0 for Linux 2.4
Based upon Swansea University Computer Society NET3.039
Initializing RT netlink socket
Starting kswapd
Journalled Block Device driver loaded
devfs: v1.12c (20020818) Richard Gooch (rgooch@atnf.csiro.au)
devfs: boot_options: 0x1
pty: 256 Unix98 ptys configured
Floppy drive(s): fd0 is 1.44M
FDC 0 is a post-1991 82077
Uniform Multi-Platform E-IDE driver Revision: 7.00beta4-2.4
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
SIS5513: IDE controller at PCI slot 00:00.1
SIS5513: chipset revision 208
SIS5513: not 100% native mode: will probe irqs later
SIS5513: SiS630 ATA 100 (1st gen) controller
    ide0: BM-DMA at 0xd800-0xd807, BIOS settings: hda:DMA, hdb:pio
    ide1: BM-DMA at 0xd808-0xd80f, BIOS settings: hdc:pio, hdd:pio
hda: ST32122A, ATA DISK drive
blk: queue c0283e60, I/O limit 4095Mb (mask 0xffffffff)
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
hda: attached ide-disk driver.
hda: 4124736 sectors (2112 MB) w/128KiB Cache, CHS=1023/64/63, UDMA(33)
Partition check:
 /dev/ide/host0/bus0/target0/lun0: p1 p2
NET4: Linux TCP/IP 1.0 for NET4.0
IP Protocols: ICMP, UDP, TCP
IP: routing cache hash table of 512 buckets, 4Kbytes
TCP: Hash tables configured (established 4096 bind 8192)
NET4: Unix domain sockets 1.0/SMP for Linux NET4.0.
EXT3-fs: INFO: recovery required on readonly filesystem.
EXT3-fs: write access will be enabled during recovery.
kjournald starting.  Commit interval 5 seconds
EXT3-fs: recovery complete.
EXT3-fs: mounted filesystem with ordered data mode.
VFS: Mounted root (ext3 filesystem) readonly.
Mounted devfs on /dev
Freeing unused kernel memory: 72k freed
EXT3 FS 2.4-0.9.19, 19 August 2002 on ide0(3,1), internal journal
Adding Swap: 127000k swap-space (priority -1)
Linux Tulip driver version 0.9.15-pre12 (Aug 9, 2002)
PCI: Found IRQ 10 for device 00:0d.0
PCI: Sharing IRQ 10 with 01:00.0
tulip0:  EEPROM default media type Autosense.
tulip0:  Index #0 - Media 10baseT (#0) described by a 21142 Serial PHY (2) block.
tulip0:  Index #1 - Media 10baseT-FDX (#4) described by a 21142 Serial PHY (2) block.
tulip0:  Index #2 - Media 100baseTx (#3) described by a 21143 SYM PHY (4) block.
tulip0:  Index #3 - Media 100baseTx-FDX (#5) described by a 21143 SYM PHY (4) block.
eth0: Digital DS21143 Tulip rev 65 at 0x9800, 00:40:F6:0C:B3:AD, IRQ 10.
PCI: Found IRQ 11 for device 00:0e.0
tulip1:  EEPROM default media type Autosense.
tulip1:  Index #0 - Media 10baseT (#0) described by a 21142 Serial PHY (2) block.
tulip1:  Index #1 - Media 10baseT-FDX (#4) described by a 21142 Serial PHY (2) block.
tulip1:  Index #2 - Media 100baseTx (#3) described by a 21143 SYM PHY (4) block.
tulip1:  Index #3 - Media 100baseTx-FDX (#5) described by a 21143 SYM PHY (4) block.
eth1: Digital DS21143 Tulip rev 65 at 0x9400, 00:40:F6:F4:4E:65, IRQ 11.
ip_tables: (C) 2000-2002 Netfilter core team
ip_conntrack version 2.1 (495 buckets, 3960 max) - 288 bytes per conntrack
CSLIP: code copyright 1989 Regents of the University of California
PPP generic driver version 2.4.2
