Hi,
These are the version 4 patches to implement eMMC4.4 HW reset
feature. Host controller can use this feature by trigger RST_n signal.
To enable this, byte 162 of EXT_CSD register should be set.
HW reset is implemented in mmc core layer and sdhci host layer, and it
will be used after each reading/writing/erasing timeout error occures.
change-log:
This version change the way to detect timeout error conditions. Added a
new routine mmc_handle_timeout_error to do this instead to do this in
mmc_wait_for_req. Each timeout read/write/erase command can use this
routine to do HW reset.
patch1: enable HW reset capability if card support.
patch2: add two new callback to implement HW reset in mmc core layer. In
this patch, routine mmc_handle_timeout_error was added.
patch3: implement hardware_reset callback for sdhci host. A new callback
reset_emmc was defined which will be each sdhci host controller to
implement separately.
patch4: did a HW reset after each read/write/erase command.
Thanks
Chuanxiao
--
To unsubscribe from this list: send the line "unsubscribe linux-mmc" in
the body of a message to majord...@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
