Hi Andy: Thanks for your help , my board's all eth ports works now , according the file you give out: " arch/ppc/ platforms/85xx/mpc8540_ads.c " , I modified the TSEC ID from 0,1 to 4,5 , and modified the TFEC interrupt source from 5 to 7 , after these modification , my board can work.
Thanks a lot! KylongMu On Jul 26, 2005, at 01:02, KylongMu wrote: > > eth0 and eth1 not work, they are giga ethernet , but eth2 work well , > I know all of them are drived under same driver " drivers/net/gianfar* > ", and I checked the 8540 datasheet , because the MAC is integrated , > the only deferent is the PHY , the 2.4.18 kernel come with my board is > work well at all eth port , so I'm sure the hardware is OK On Jul 27, 2005, at 02:26, Andy Fleming wrote: The manual says the PHY addresses for TSEC 1 and TSEC 2 are: TSEC1: 4 TSEC2: 5 The 8540 ADS has this configuration: TSEC1: 0 TSEC2: 1 The correct solution would be to make a new board file for the SK board, and properly configure everything. However, if you insist on using the 8540 ADS config for this, you will need to change arch/ppc/ platforms/85xx/mpc8540_ads.c so that TSEC1 and TSEC2 have their phyid platform data fields assigned to be: TSEC1: 4 TSEC2: 5