Cindy Pearce wrote:
> I installed Mandrake 5.3 using the stock Workstation install. My printer is on
> LPT1 ,which I think is lp0, and I would like to enable parallel port support in
> this kernel. When I try to run "make xconfig" as instructed in the Kernel
Why do you think parallel port support isn't enabled already? At least
in my installation (also of Mandrake 5.3), the printer is supported just
fine, and it sees the printer port.
--
Dan Brown, KE6MKS, [EMAIL PROTECTED]
Meddle not in the affairs of dragons, for you are crunchy and taste good
with ketchup.
