Just so theres no mis-understanding, I did not do any of the steps that
Richard suggested. Out of ignorance I ass-umed that an autoprobe would be
performed during install.
tks
----- Original Message -----
From: Chris Hughes <[EMAIL PROTECTED]>
To: <[EMAIL PROTECTED]>
Sent: Tuesday, September 07, 1999 3:37 PM
Subject: Re: [newbie] Ethernet NIC not recognized
> Richard,
>
> Wrong: "You have defined it as a module right.? "
> Rignt: "you have not entered the following into /etc/conf.modules"
>
> Thanks for the response. I thought an autoprobe should have detected it.
> I'll give it another try.
>
>
> -----Original Message-----
> From: Richard Adams <[EMAIL PROTECTED]>
> To: [EMAIL PROTECTED] <[EMAIL PROTECTED]>
> Date: Tuesday, September 07, 1999 7:58 AM
> Subject: Re: [newbie] Ethernet NIC not recognized
>
>
> >On Tue, 07 Sep 1999, you wrote:
> >> I have just installed Mandrake 6. Unfortunately my 3Com 3C515TX was
not
> >> recognized. How do I get this up? The logs just say "Delaying start
of
> >> eth0"
> >
> >You have defined it as a module right.? you have not entered te
> >following into /etc/conf.modules
> >
> >aslias eth0 3c515
> >
> >right.?
> >
> >If you have then check your system logs you may need to add irq and
> >io addresses with the options commands in /etc/conf.modules.
> >
> >man conf.modules for examples.
> >
> >
> >
> >> thanks.
> >--
> >Regards Richard
> >[EMAIL PROTECTED]
> >
>