> Thanks for the reply, but I have upgraded all packages available which in the 
> past has resolved the cdrw problem, and no go.  The problem with the compact 
> flash reader is that I  can not find it recognized as any device anywhere. 
> Does not show up under /dev/usb,  /scsi , /sda ,  or anything else.  It shows 
> up under usbview as shown below, I just don't know how to access it. It is 
> formatted as fat  and works ok with the drivers supplied for windows 98 on a 
> M$ machine.
> 
> usb-storage
> Speed: 12Mb/s (full)
> USB Version:  1.10
> Device Class: 00(>ifc )
> Device Subclass: 00
> Device Protocol: 00
> Maximum Default Endpoint Size: 8
> Number of Configurations: 1
> Vendor Id: 05e3
> Product Id: 0700
> Revision Number:  1.13
> 
> Config Number: 1
>       Number of Interfaces: 1
>       Attributes: 80
>       MaxPower Needed:  96mA
> 
>       Interface Number: 0
>               Name: usb-storage
>               Alternate Number: 0
>               Class: 08(stor.) 
>               Sub Class: 6
>               Protocol: 50
>               Number of Endpoints: 2
> 
>                       Endpoint Address: 81
>                       Direction: in
>                       Attribute: 2
>                       Type: Bulk
>                       Max Packet Size: 64
>                       Interval:   0ms
> 
>                       Endpoint Address: 02
>                       Direction: out
>                       Attribute: 2
>                       Type: Bulk
>                       Max Packet Size: 64
>                       Interval:   0ms
> -- 
> Dennis M. linux user #180842
 

Are you plugged in through a hub or directly to a usb port?  PNY recommends going 
direct to the USB port for Windows.  Not sure why it should make a difference, though.

Again, I'm using the SmartMedia reader not the CompactFlash reader.  I also have the 
stock 8.2 kernel loaded and I am running devfs (you might try turning it on/off 
depending on whether it is on or off now).

It sounds like the reader is detected okay, but it is failing to assign it to a scsi 
port.  You could try to manually create the scsi port under /dev and see if that fixes 
it.  It would be something like /dev/scsi/host1/bus0/target0/lun0/disc.  Upto /disc, 
everything is just a folder.  I'm not sure how to create the /disc part which is the 
actual device, though.

Probably, not much help, huh?  

Joe

Want to buy your Pack or Services from MandrakeSoft? 
Go to http://www.mandrakestore.com

Reply via email to