On Tuesday 18 Feb 2003 1:11 am, Roger Sherman wrote: > > Roger, I think the alarm is showing because your readout is below the > > minimums set in the sensor config. I use ksensors and have had to reduce > > the minimums to reset the alarm for lowvoltage and low rpms. HTH > > Right, I figured that part, but what I really want to know is, should I be > worried about the amounts showing, especially with the voltage? I have no > problem ignoring the message so long as I know that I'm not powering the > CPU incorrectly.
FWIW I used to have a problem under w2k with the mobo sensors showing low voltages and setting off alarms all over. I talked to the mobo supplier, who said that if there really was a problem with voltages critically low I would have had endless trouble with my installed system. Since I hadn't it was most likely a problem with the sensor software. I downloaded the update, and all was well after thatl. HTH Anne -- Registered Linux User No.293302
Want to buy your Pack or Services from MandrakeSoft? Go to http://www.mandrakestore.com