Troy
It is telling you that your video card (or chip set) is not supported and
therefore the DrakX installation can not continue.
What graphics card do you have?
You could install in text mode but unless when can figure a solution to
your video card you would not be able to run KDE.
Charles
PS: Please
1) Increase your font size
2) Send your postings in text mode not HTML
PPS: Do they still print the Sgt. Rock comic?
----- Original Message -----
From: "SGT_ROCK" <[EMAIL PROTECTED]>
To: <[EMAIL PROTECTED]>
Sent: Friday, May 19, 2000 11:42 PM
Subject: [newbie] Install dies during installation
Problem:
I boot off of the CD and get to the point where the packages are being to
install. I think then system attempts to boot to the graphical install mode
and fails. I get all kinds of crap on the screen. See below.
Perl: warning falling back to the standard locale ("C")
Date Time Gdk-WARNING **: locale not supported by C library at
/usr/bin/perl-install/install_steps_gtkp line 240
Install exited abnormally -- revived signal 11
(--) FBDev Frame buffer device: VESA VGA
(--) FBDev Video memory :4096K @ 0xfd000000
(--) FBDev MMIOregs:OK @ (nil)
(--) FBDev type_aux 0 bits-per-pixel 16
(--) FBDev Hardware acceleration
(--) FBDev No driver support for hardware
(--) FBDev acceleration bpp=16, depth=16, bits per RGB=6
(--) FBDev Using Cfb 16 driver
error opening security policy file /usr/X11R6/lib/X11/xserver/security
Policy
sending termination signals.. done
Any clue as to what might be wrong???
Thanks,
Troy
