[Spanish Version Down] [Versión Española Abajo] Hi again to all, Like I heard in one other mail in this list, I think that Mandrake 7.1 isn't tested enough, I'm going lot of problems during the installation, now all the RPM packages installed ok, but when I try to install the bootloader, (I want to use GRUB because I got the Linux in the cylinder 23.xxx), all goes well, but when the program starts to install GRUB i got this error, "LILO ERROR: XXXX - Cylinder 23.xxx > 1.024", one thing, How can I'm getting this ERROR IF I'M INSTALLING GRUB????? I got installed previously Mandrake 7.0-2 and I tryed to make and Actualization, perhaps is because I must uninstall lilo before? Say me someting ok? thanks for all, Iagoba. ------------------------------------------------------------------------- Hola de nuevo a todos, Igual que lo que he leido en otro mail en esta lista, pienso que el Mandrake 7.1 no ha sido testeado lo suficiente, Estoy teniendo un monton de probelmas durante la instalación, ahora todos los paquetes RPM están instalados, pero cuando intento instalar el bootloader, (quiero usar el GRUB porque tengo el Linux en el Cilindro 23.xxx y pico), todo va bien, pero cuando el programa se supone que está instalando GRUB tengo el siguiente error, "LILO ERROR: XXXX - Cilindro 23.xxx > 1.024", una cosita, ¿Cómo puedo tener este error SI ESTOY INSTALANDO EL GRUB????????? Tenia instalado previamente el Mandrake 7.0-2 y he tratado de hacer una actualización, quizá es porque debo desinstalar lilo antes? Decidme algo vale? gracias por todo, Iagoba.