Hi Mike it seems the buffer_len parameter you are passing to pfring_zc_create_cluster() is not big enough, please refer to zcount to get the correct value.
Alfredo > On 06 Oct 2015, at 23:57, Michael Nicolazzo <[email protected]> wrote: > > Hi, > > I have an issue with my application using ZC and I hope you can provide some > insight to where the problem might be. The application runs perfectly using > standard drivers. But when I run the ZC aware driver (ixgbe) and attempt to > open the device with zc:eth3, the call to pfring_zc_open_device fails with > errno = 94. Zcount runs fine, so I assume I have installed the driver > properly. Any thoughts? > > Thanks, > > Mike > > _______________________________________________ > Ntop-misc mailing list > [email protected] > http://listgateway.unipi.it/mailman/listinfo/ntop-misc _______________________________________________ Ntop-misc mailing list [email protected] http://listgateway.unipi.it/mailman/listinfo/ntop-misc
