On Jun 25, 2010, at 8:56 AM, Henk van Lingen wrote:
in ups.conf. I can read the variables using upsc. However it seems,
I can't actually execute commands on the UPSses this way.
( upscmd some-ups calibrate.start )
Some things I probably should have asked earlier:
1) Is this command actually listed in the output of "upscmd -l"?
2) Are you including the appropriate username/password parameters to
upscmd? (I see two spaces after upscmd, as though you removed your
username and password, but I figure it can't hurt to ask.)
3) Are there any log messages from upsd?
4) Does the calibration work if you manually run something like:
"snmpset <host-and-community> PowerNet-
MIB::upsAdvTestRuntimeCalibration.0 i 2" ?
(if it does, you should be able to stop it by changing the "2" to a
"3").
I am CC'ing Arnaud in case he has additional debugging tips.
_______________________________________________
Nut-upsuser mailing list
[email protected]
http://lists.alioth.debian.org/mailman/listinfo/nut-upsuser
