On Wed, Jun 30, 2010 at 08:30:38PM -0400, Charles Lepple wrote: > On Jun 25, 2010, at 8:56 AM, Henk van Lingen wrote: > > >in ups.conf. I can read the variables using upsc. However it seems, > >I can't actually execute commands on the UPSses this way. > >( upscmd some-ups calibrate.start ) > > Some things I probably should have asked earlier: > > 1) Is this command actually listed in the output of "upscmd -l"?
No, it lists no commands at all: h...@swizzy:~-$ upscmd -l snmp Instant commands supported on UPS [snmp]: h...@swizzy:~-$ Hence my initial question about any commands being available by the way of the snmp driver. > 2) Are you including the appropriate username/password parameters to > upscmd? (I see two spaces after upscmd, as though you removed your > username and password, but I figure it can't hurt to ask.) No, but it asks for them, and I give the ones which i have in upsd.users: h...@swizzy:~-$ upscmd snmp calibrate.start Username (henk): **** Password: Instant command failed: Instant command not supported h...@swizzy:~-$ > 3) Are there any log messages from upsd? No. Regards, -- +----------------------------------------------------------------------+ | (o- Henk van Lingen Utrecht, The Netherlands | | /\ http://henk.vanlingen.net/ | | v_/_ http://www.tuxtown.net/netiquette/ | + Using Outlook ? -> http://home.in.tum.de/~jain/software/oe-quotefix/ + _______________________________________________ Nut-upsuser mailing list [email protected] http://lists.alioth.debian.org/mailman/listinfo/nut-upsuser
