Hi Ian I think I can scan or take a large photo for you to evaluate the registration of solder mask, do you need it?
Best Regards Mike Beijing Draco Electronics Ltd. +86 10 82634949 http://www.ezpcb.com [EMAIL PROTECTED] 2005-05-19 >Has anyone got good recommendations for high end PCB makers. We need >reasonable width and spacing (5 mil / 5 mil) but good drill rout accuracy. >Also, looking to minimise the solder mask expansion as far as possible for >a number of reasons - so need good solder mask registration. > >Our client is nervous about the normal PCB makers we normally use (here in >Australia). While lead time is not too important, it is not a >non-consideration. Europe, Asia or Canada/US are all acceptable if they >can do a quality job especially on registration of drill, rout and solder mask. > >Many thanks, >Ian Wilson > > >____________________________________________________________ >You are subscribed to the OT discussion forum > >To Post messages: >mailto:[email protected] > >Unsubscribe and Other Options: >http://techservinc.com/mailman/listinfo/ot_techservinc.com > >Browse or Search Old Archives (2001-2004): >http://www.mail-archive.com/[email protected] > >Browse or Search Current Archives (2004-Current): >http://www.mail-archive.com/[email protected] ____________________________________________________________ You are subscribed to the OT discussion forum To Post messages: mailto:[email protected] Unsubscribe and Other Options: http://techservinc.com/mailman/listinfo/ot_techservinc.com Browse or Search Old Archives (2001-2004): http://www.mail-archive.com/[email protected] Browse or Search Current Archives (2004-Current): http://www.mail-archive.com/[email protected]
