Ian,
I could recommend that you try one fabricator I have used in the past
with very good results. They aren't cheap but I found their quality and process
control to be flawless. In particular we tried them out on a design requiring
very very tight plate and etch control, they surpassed our expectations by
miles.
The company is Hallmark Circuits, San Diego, CA. Here is their link:
http://www.hallmarkcircuits.com/
My contact there was Bento Dantas (great guy) his direct number is:
(503) 653-9480 or his email is [EMAIL PROTECTED]
They do anything from prototypes through larger jobs although they
specialize in small to medium specialty jobs.
Sincerely,
Brad Velander
Senior PCB Designer
Northern Airborne Technology
1925 Kirschner Rd.,
Kelowna, BC, V1Y 4N7.
tel (250) 763-2329 ext. 225
fax (250) 762-3374
-----Original Message-----
From: Ian Wilson [mailto:[EMAIL PROTECTED]
Sent: May 18, 2005 7:18 PM
To: [email protected]
Subject: [SPAM] - [OT] High quality PCB makers - Email found in subject
Has anyone got good recommendations for high end PCB makers. We need
reasonable width and spacing (5 mil / 5 mil) but good drill rout accuracy.
Also, looking to minimise the solder mask expansion as far as possible for
a number of reasons - so need good solder mask registration.
Our client is nervous about the normal PCB makers we normally use (here in
Australia). While lead time is not too important, it is not a
non-consideration. Europe, Asia or Canada/US are all acceptable if they
can do a quality job especially on registration of drill, rout and solder mask.
Many thanks,
Ian Wilson
____________________________________________________________
You are subscribed to the OT discussion forum
To Post messages:
mailto:[email protected]
Unsubscribe and Other Options:
http://techservinc.com/mailman/listinfo/ot_techservinc.com
Browse or Search Old Archives (2001-2004):
http://www.mail-archive.com/[email protected]
Browse or Search Current Archives (2004-Current):
http://www.mail-archive.com/[email protected]
