Hello to everybody,
I have a problem with the corosync.conf setup. I have a drbd service
runing on eth3, and a general network and the stonith device (idrac6) in
the eth0. If I unplug the eth3 to simulate a network failure two nodes
are fenced (first the slave followed by the master). If I only leave
ringnumber 0 in the coroync.conf file I don't have this problem. Is this
normal operation?
Here you have the section of corosync.conf where I have the problem, and
thanks for the help.
rrp_mode: active
interface {
# eth0
ringnumber: 0
bindnetaddr: 200.200.201.0
mcastaddr: 226.94.1.1
mcastport: 5405
}
interface {
#eth3
ringnumber: 1
bindnetaddr: 192.168.2.0
mcastaddr: 226.94.1.2
mcastport: 5406
}
-----
Ivan
_______________________________________________
Pacemaker mailing list: Pacemaker@oss.clusterlabs.org
http://oss.clusterlabs.org/mailman/listinfo/pacemaker
Project Home: http://www.clusterlabs.org
Getting started: http://www.clusterlabs.org/doc/Cluster_from_Scratch.pdf
