I found that if I only blacklist the snd_asihpi then I can still use the onboard sound for Audacity editing while Riv uses the ASI. In my case, that does not appear to cause any errors and works fine.
Tom Van Gorkom Radio Esperanza Engineering, KRIO AM/FM, KOIR FM Office: 956-380-8150 Cell: 865-803-7427 Rio Grande Bible Institute 4300 S US Hwy 281 Edinburg, TX 78539 On Sun, Sep 16, 2018 at 6:48 PM Tom Van Gorkom <tomvangor...@gmail.com> wrote: > Thank you for the tip. I should have looked in Dmesg sooner.... it said > the asihpi failed to load because it was missing a signature or required > key. As I read up on this, I found several cases where it seems that both > drivers try to load at the same time. By blacklisting them, you end up with > no active card in RDAlsaconfig but Rivendell has the correct audio > resources using the correct ASIHPI driver. > > Thanks, > > Tom Van Gorkom > Radio Esperanza Engineering, KRIO AM/FM, KOIR FM > Office: 956-380-8150 > Cell: 865-803-7427 > > Rio Grande Bible Institute > 4300 S US Hwy 281 > Edinburg, TX 78539 > > > On Sat, Sep 15, 2018 at 5:02 PM Andy Higginson <a...@higgles.co.uk> wrote: > >> Ok, quick stab in the dark as I don’t know this card. However my >> experience with setting up an ASI6520 a couple of weeks ago via the script >> was that I needed to blacklist the ALSA ASI driver. From my question to >> check that I got it right comes this. >> >> >> >> I'm setting up my Rivendell host using the script installer on CentOS 7. >> The host has an ASI6520 soundcard in it. Looking though dmesg and via the >> RDAlsaConfig utility it seems that the soundcard is running with both ALSA >> and native ASIHPI support. Therefore I have created a blacklist file in >> /etc/modprobe.d called asi-blacklist.conf. This contains 2 lines - >> "blacklist snd_asihpi" and "blacklist snd_hda_intel". The system now only >> has AudioScience HPI listed for the driver and the version in use is >> 4.13.00. >> >> >> I hope this helps. >> >> Andy >> >> >> >> >> >> On 15 Sep 2018, at 22:11, Tom Van Gorkom <tomvangor...@gmail.com> wrote: >> >> New CentOs 7 script install of Riv 2.19.2 >> >> Why would the audio on the ASI only work for playout and recording from >> Rivendell when I select HD-Audio Generic ALC1150 Analog [1] in >> RdAlsaConfig and not when the actual AudioScience ASI6114 0-Asihpi PCM [1] >> is selected? >> >> In RdAdmin, Hosts, Audio Resources, the ASI card shows up as card 0, >> Driver: AudioScience HPI, Inputs: 1, Outputs: 4 and the selected card in >> RdAlsaConfig shows as an active Card 1 using Alsa driver. The inputs and >> outputs of the ASI work as they should. Just different behavior than >> expected. >> >> Explanations? OK as is? >> >> Tom Van Gorkom >> Radio Esperanza Engineering, KRIO AM/FM, KOIR FM >> Office: 956-380-8150 >> Cell: 865-803-7427 >> >> Rio Grande Bible Institute >> 4300 S US Hwy 281 >> Edinburg, TX 78539 >> _______________________________________________ >> Rivendell-dev mailing list >> Rivendell-dev@lists.rivendellaudio.org >> http://caspian.paravelsystems.com/mailman/listinfo/rivendell-dev >> >> >> _______________________________________________ >> Rivendell-dev mailing list >> Rivendell-dev@lists.rivendellaudio.org >> http://caspian.paravelsystems.com/mailman/listinfo/rivendell-dev >> >
_______________________________________________ Rivendell-dev mailing list Rivendell-dev@lists.rivendellaudio.org http://caspian.paravelsystems.com/mailman/listinfo/rivendell-dev
