Re: [j-nsp] Recommended firmware for QFX5100-48T

Hi Dale, Yeah, seems to be the case. I tried configuring one as GE, the show command simply said it couldn't find that interface afterwards. Auto negotiation being turned on doesn't seem to matter, it linked up even without it. On sh int xe-0/0/0 media, you can however find these:

Re: [j-nsp] Recommended firmware for QFX5100-48T

You can set "ether-options autonegotiate" on XE interfaces, and it will do just as you'd expect. Firmware on QFX-5100-48T is bad in a lot of ways, but we've gotten them to work mostly as youd want. We are on 14.1X53-D35.3 xe-0/0/0 { ether-options { auto-negotiation;

Re: [j-nsp] Recommended firmware for QFX5100-48T

Hi all, On 11 Oct 2016 6:23 AM, "Graham Brown" wrote: > > Hi Paul, > > Correct, just use 'replace pattern xe-0/0/0 with ge-0/0/0' etc and you > should be fine. I don't think that's how it works on qfx5100-48**T** It's more like copper based EX, where the interfaces are configured as ge-x/x/x ev

Re: [j-nsp] Recommended firmware for QFX5100-48T

Hi Paul, Correct, just use 'replace pattern xe-0/0/0 with ge-0/0/0' etc and you should be fine. Cheers, Graham Graham Brown Twitter - @mountainrescuer LinkedIn On 11 October 2016 at 07:05, Paul S. wrote: > Hi J

Re: [j-nsp] Recommended firmware for QFX5100-48T

Hi Joel, Thanks for replying. What are the steps to configure the ports as "ge." Do I just get rid of xe from the config and replace it with ge for that port, that's all? On 10/11/2016 12:21 AM, joel jaeggli wrote: On 10/10/16 7:34 AM, Paul S. wrote: Hi folks, Are everyone running the JTAC

[j-nsp] Virtual Chassis Fabric ports and LAG

I've set up four QFX devices in a lab. Two QFX5100-24Q as the spine members and two QFX-5100-48T as the leaf nodes. I connected two 40GbE links from each spine to each leaf member. According to the documentation the VCPs are supposed to figure out a LAG on their own. I can't tell for certain if

Re: [j-nsp] Recommended firmware for QFX5100-48T

On 10/10/16 7:34 AM, Paul S. wrote: > Hi folks, > > Are everyone running the JTAC recommended 14.1X53-D35.3 or have you > found better stability at some newer revision? > > My problem is that the "tri state" 10g ports (copper) don't seem to > want to run at anything less than 10g. It links up when

[j-nsp] Recommended firmware for QFX5100-48T

Hi folks, Are everyone running the JTAC recommended 14.1X53-D35.3 or have you found better stability at some newer revision? My problem is that the "tri state" 10g ports (copper) don't seem to want to run at anything less than 10g. It links up when connected to a 1g device, but still claims