> We are trying to migrate a frame relay network onto our mpls network,
> based on juniper M10i routers.
> We are using frame-relay-ccc encapsulation and l2circuit configuration.
> The problem is that we are unable to configure dlci values below 512.
> We get the following error when trying to co
Hi Amos,
Just to complete the excellent answer of Sean.
In the documentation I can read :
"Like Ethernet interfaces, a Frame Relay interface requires the
specification of CCC encapsulation at both the device and logical unit
levels. When the device is set to support CCC encapsulation, Frame Re
Amos,
normally all ccc are vlan id / dlci 512-1023. You might want
to try 'extended-frame-relay-ccc' and it should take all of
those as CCC - but you will then not be able to use any of
the DLCIs for, say, IP or so. All CCC or 512-1023. I hope
that helps a bit already.
Alexander
On Mon, 6 August
At 6:11 PM +0300 8/6/07, Amos Rosenboim wrote:
>Hello All,
>
>We are trying to migrate a frame relay network onto our mpls network,
>based on juniper M10i routers.
>We are using frame-relay-ccc encapsulation and l2circuit configuration.
>The problem is that we are unable to configure dlci values b
Hello All,
We are trying to migrate a frame relay network onto our mpls network,
based on juniper M10i routers.
We are using frame-relay-ccc encapsulation and l2circuit configuration.
The problem is that we are unable to configure dlci values below 512.
We get the following error when trying to
5 matches
Mail list logo