Ahhh, ok!!!
:) :) :)
Cristian
El 22/12/2010 7:52, juniper light escribió:
I found the solution guy, and it was realy some thing stupid : it is a story
of numbering
from what I was configuring and what I was cabling : left to right or right
to left
when i was configuring fe-0/3/0
hi again ,
i tried this time using 1x G/E, 1000 BASE-SX connected to annother router
and it is working.
but I'm still trying to figure out why back to back link ( crossover cable)
on the same physical router is nnot working,
I added new 4x F/E, 100 BASE-TX PIC and trying to crossconnect the 2 PIC
I found the solution guy, and it was realy some thing stupid : it is a story
of numbering
from what I was configuring and what I was cabling : left to right or right
to left
when i was configuring fe-0/3/0 I was cabling fe-0/3/3 :
IF NUMBER ARE FROM RIGHT TO LEFT AND NOT FROM LEFT TO RIGHT
Ok,
It looks like a hardware problem (at PIC or EFEB level, may be).
I´d be a good idea to change the cable too just in case
Check with show log chassid , may be you can find some log related to a
physical problem.
Also check with a show route logical-router PE2 or PE3. You must find
I didn't change cabling, but I connected a new interface to annother router
and I'm having the same problem, the new interface is in the default
configuration :
set interfaces fe-0/3/2 unit 0 family inet address 10.0.24.2/30
ad...@m10> show interfaces terse
Interface Admin Link Proto
Hi!!
I'd try to change ports pairs, and to switch the PIC to a different fpc
slot, just to be sure that there is no hardware issue
The configuration looks fine
Cristian
El 21/12/2010 15:07, juniper light escribió:
Hi guys,
I would like to use M10 to simulate 3 PE, using logical-rou
Hi guys,
I would like to use M10 to simulate 3 PE, using logical-routers ( Junos
8.4R4.2 )
I connected 2 fastethernet back-to-back, link are UP. but when I tried
configuring vlan-id , I cannot ping from one Logical router to the other :
first scenario using Vlan-tagging :
set logical-routers PE2
7 matches
Mail list logo
