Robert,
Thanks. At least it loaded right up as shown on the serial terminal. Now it
is at least looking for the ext4 filesystem before loading the ext2
filesystem.
Something that I read suggested that the journal-ing stuff on ext4 could
shorten the life of the uSD card but that the ext4 has hig
On Mon, Aug 21, 2017 at 4:56 PM, mugginsac wrote:
> Here is what I am getting from trying to boot the uSD I built. Is it
> possible that I have a bad uSD?
>
> U-Boot SPL 2017.05 (Aug 20 2017 - 08:57:37)
> drivers/ddr/altera/sequencer.c: Preparing to start memory calibration
> drivers/ddr/altera/se
On 8/21/2017 5:59 PM, mugginsac wrote:
> Charles,
>
> What terminal software are you using?
> Is there any special setup required other than 115,200 baud and 8N1
> (data,parity, and stop bits)?
> I can't get putty to work with the DE10 and I sometimes get those weird
> single column scroll down
The problem appears to be a small amount of flex in the linear rods. I used
8mm rods thinking that the stresses wouldn't very much when used as a drag
engraver. I will probably up size the rods to 12mm in the final design
version. The 8mm rods would probably be fine for laser engraving.
On Fri
Charles,
What terminal software are you using?
Is there any special setup required other than 115,200 baud and 8N1
(data,parity, and stop bits)?
I can't get putty to work with the DE10 and I sometimes get those weird
single column scroll down the right hand side with minicom.
Alan
--
website:
On 8/21/2017 4:56 PM, mugginsac wrote:
> Here is what I am getting from trying to boot the uSD I built. Is it
> possible that I have a bad uSD?
Your uSD is probably fine.
There's a CRC error because you don't (yet) have a saved U-Boot
environment on the A2 partition. Based on the output you ar
Here is what I am getting from trying to boot the uSD I built. Is it
possible that I have a bad uSD?
U-Boot SPL 2017.05 (Aug 20 2017 - 08:57:37)
drivers/ddr/altera/sequencer.c: Preparing to start memory calibration
drivers/ddr/altera/sequencer.c: CALIBRATION PASSED
drivers/ddr/altera/sequencer.c
Taking a break from watching the progress of the solar eclipse.
What I am trying to do is get to the point of building a system that will
run with HDMI before I start trying to add MachineKit and the hm2 stuff.
At the moment the build doesn't seem to run HDMI. I thought I was using the
same dtbs