Hello Partrice,
Am 09.08.2017 um 14:45 schrieb patrice.chot...@st.com:
From: Patrice Chotard <patrice.chot...@st.com>
Add i2c driver which can be used on both STM32F7 and STM32H7.
This I2C block supports the following features:
_ Slave and master modes
_ Multimaster capability
_ Standard-mode (up to 100 kHz)
_ Fast-mode (up to 400 kHz)
_ Fast-mode Plus (up to 1 MHz)
_ 7-bit and 10-bit addressing mode
_ Multiple 7-bit slave addresses (2 addresses, 1 with configurable mask)
_ All 7-bit addresses acknowledge mode
_ General call
_ Programmable setup and hold times
_ Easy to use event management
_ Optional clock stretching
_ Software reset
Signed-off-by: Christophe Kerello <christophe.kere...@st.com>
Signed-off-by: Patrice Chotard <patrice.chot...@st.com>
---
v2: _ add I2C controller description in Kconfig
_ rename stm32_i2c_dev struct to stm32_i2c_priv
_ add comment for stm32_i2c_handle_reload()
_ split stm32_i2c_compute_timing() code and add :
_ stm32_i2c_compute_solutions() which computes list of possible
timings candidate
_ stm32_i2c_choose_solution() which selects the best timing
_ use #defines instead of hard coded vlaue for speed in
stm32_i2c_set_bus_speed() and in i2c_specs[] array
_ move part of code of stm32_i2c_probe() inside
stm32_ofdata_to_platdata()
doc/device-tree-bindings/i2c/i2c-stm32.txt | 30 +
drivers/i2c/Kconfig | 20 +
drivers/i2c/Makefile | 1 +
drivers/i2c/stm32f7_i2c.c | 882 +++++++++++++++++++++++++++++
4 files changed, 933 insertions(+)
create mode 100644 doc/device-tree-bindings/i2c/i2c-stm32.txt
create mode 100644 drivers/i2c/stm32f7_i2c.c
Applied to u-boot-i2c.git master
Thanks!
bye,
Heiko
--
DENX Software Engineering GmbH, Managing Director: Wolfgang Denk
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
https://lists.denx.de/listinfo/u-boot