From: Patrick Delaunay <patrick.delau...@foss.st.com> Activate the command stm32prog with CONFIG_CMD_STM32MPROG. The CONFIG_SET_DFU_ALT_INFO is also activated to support the required weak functions for the DFU virtual backen defined in board/st/common/stm32mp_dfu.c.
Signed-off-by: Patrick Delaunay <patrick.delau...@foss.st.com> Signed-off-by: Patrice Chotard <patrice.chot...@foss.st.com> --- configs/stm32mp13_defconfig | 2 ++ include/configs/stm32mp13_common.h | 4 ++++ 2 files changed, 6 insertions(+) diff --git a/configs/stm32mp13_defconfig b/configs/stm32mp13_defconfig index f962d0eab97..2d87792a9cb 100644 --- a/configs/stm32mp13_defconfig +++ b/configs/stm32mp13_defconfig @@ -11,6 +11,7 @@ CONFIG_DDR_CACHEABLE_SIZE=0x8000000 CONFIG_CMD_STM32KEY=y CONFIG_TARGET_ST_STM32MP13x=y CONFIG_ENV_OFFSET_REDUND=0x940000 +CONFIG_CMD_STM32PROG=y # CONFIG_ARMV7_NONSEC is not set CONFIG_SYS_LOAD_ADDR=0xc2000000 CONFIG_SYS_MEMTEST_START=0xc0000000 @@ -51,6 +52,7 @@ CONFIG_SYS_RELOC_GD_ENV_ADDR=y CONFIG_SYS_MMC_ENV_DEV=-1 CONFIG_ENV_MMC_USE_DT=y CONFIG_CLK_SCMI=y +CONFIG_SET_DFU_ALT_INFO=y CONFIG_GPIO_HOG=y CONFIG_DM_I2C=y CONFIG_SYS_I2C_STM32F7=y diff --git a/include/configs/stm32mp13_common.h b/include/configs/stm32mp13_common.h index 7c59c69e0bd..d36fbf00548 100644 --- a/include/configs/stm32mp13_common.h +++ b/include/configs/stm32mp13_common.h @@ -41,10 +41,14 @@ /* * default bootcmd for stm32mp13: + * for serial/usb: execute the stm32prog command * for mmc boot (eMMC, SD card), distro boot on the same mmc device */ #define STM32MP_BOOTCMD "bootcmd_stm32mp=" \ "echo \"Boot over ${boot_device}${boot_instance}!\";" \ + "if test ${boot_device} = serial || test ${boot_device} = usb;" \ + "then stm32prog ${boot_device} ${boot_instance}; " \ + "else " \ "run env_check;" \ "if test ${boot_device} = mmc;" \ "then env set boot_targets \"mmc${boot_instance}\"; fi;" \ -- 2.25.1