Good evening all I doubt if I will be of any use in the development but I have a very specific question that I felt was better asked here than on a more general forum.
the question is wrt MAP65 I am using a Angelia board from Anan as the back end for transverters and have 2 x G4DDK Anglian transverters fed from a single 116MHz source and all the radios locked to the same 10MHz source. I can now produce 2 x I&Q streams at 96000 via VAC from the two RX how can / do I feed this to MAP65, I can send either successfully and decode fine and I can TX from MAP65 fine but I cannot see how to have both RX Inputs, perhaps this is not at this stage possible without routing through Linrad or SDR-Radio but I thought it should be possible to feed the 2 streams direct to MAP65. I have been previously using a flex 1500 as the driver and feeding WSJT with a Funcube dongle feeding MAP65 as a spotting rx but now want to go full Dual polarity, and the Angelia with PowerSDRmRX PS works brilliantly and I hope to incorporate the "Pure Signal" pre-distortion scheme into the station after I get the rest sorted. Hoping some one can switch some light on for this dim bulb Jim, GI1CET ------------------------------------------------------------------------------ Dive into the World of Parallel Programming The Go Parallel Website, sponsored by Intel and developed in partnership with Slashdot Media, is your hub for all things parallel software development, from weekly thought leadership blogs to news, videos, case studies, tutorials and more. Take a look and join the conversation now. http://goparallel.sourceforge.net/ _______________________________________________ wsjt-devel mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/wsjt-devel
