Hi Kevin,
On 5/26/2020 9:27 AM, Kevin McQuiggin VE7ZD/KN7Q wrote:
I note that if you quit RC2 while in ISCAT B mode, that when you restart
the application the indicated mode on the bottom status bar is “ISCAT
B”, but that the spinner control on the window is set to “Submode A".
See the screen shot:
...
While this may just be a UI initialization issue, it is an operational
and visual distraction, so the spinner should probably be set to match
the saved submode. Support for operator situational awareness should
have the two indicators match.
Thanks for pointing out this anomaly. It will be corrected in the next
release.
Evidently you are operating with "Enable VHF/UHF/Microwave features"
unchecked. As a general policy, WSJT-X recommends using submodes (such
as JT65B, ISCAT B, etc.) only on VHF bands and higher. Unless you have
some specific reason I don't know about, you should check that box when
using ISCAT.
And then, you would never have noticed the anomaly you reported -- hi.
-- 73, Joe, K1JT
_______________________________________________
wsjt-devel mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/wsjt-devel
