On 06/03/2021 14:21, Neil Zampella wrote:
Hi,
I just installed 2.4.0-RC2 and found an issue with the auto sequencing
after an RR73 is sent. Normally, I'll click on the Enable Tx right
after I send the RR73 so that the CQ call is immediately sent as the
next Tx time slice comes up. I have the setting to clear the standard
messages checked.
However, when doing this in RC2, and a 73 reply is sent back from the
QSO partner, RC2 will repopulate the standard messages, then send a 73
instead of the CQ call.
See attached screen capture. Considering that this fix was intended to
be included in v2.3.1, I figured I had better report this ASAP. If
you need more info, please let me know. I'm not the only person
seeing this, as this was also mentioned on a FB page by another operator
earlier this morning.
Cheers,
Neil, KN3ILZ
Hi Neil,
thanks for reporting this issue, see my reply on the WSJTX Groups.io list:
https://wsjtx.groups.io/g/main/message/22948
73
Bill
G4WJS.
_______________________________________________
wsjt-devel mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/wsjt-devel
