I turned it into a generic "don't set unless necessary". Was causing power
problems on the K4 too.Hopefully it's fixed now and applies to all rigs that
can get split status and trying to set split on again. Split off will always
run a command.
Mike W9MDB
On Friday, October 15, 2021, 11:23:49 AM CDT, Bill Somerville via
wsjt-devel <[email protected]> wrote:
On 15/10/2021 16:57, Barry Jackson via wsjt-devel wrote:
On 15/10/2021 16:18, Black Michael wrote:
Since you're not getting any answer with hardware flow it sounds like you have
a 3-wire RS232 cable. So how are your cable pinouts connected?
Try this
rigctld -v -Z -vvvvv -m 2003 -s 4800 -r /dev/ttyUSB0 -t 4532
--serial_handshake=None --write_delay=5
I tried as above but got:
rigctld: unrecognized option '--serial_handshake=None
So I did:
rigctld -v -Z -vvvvv -m 2003 -s 4800 -r /dev/ttyUSB0 -t 4532 -C
serial_handshake=None,write_delay=5
Output attached which is an improvement.
I then started wsjtx and results were not good, band switching failed rather
randomly - again attached.
Cheers,
Barry
G4MKT
Hi Barry and Mike,
the problem there seems pretty straightforward, Hamlib is attempting an FT;
query and the TS-450S/TS-690S only have the set version of that command, no
query version.
73
Bill
G4WJS.
_______________________________________________
wsjt-devel mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/wsjt-devel
_______________________________________________
wsjt-devel mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/wsjt-devel
