Hi, I have prepared an Yocto SD card image "core-image-minimal-imx6q-sabresd.sdcard". I trying to flash the image onto sdcard using the command "sudo dd if= core-image-minimal-imx6q-sabresd.sdcard of=/dev/sdb bs=1M" Sync Sync
I m getting the boot messages as below U-Boot 2014.10+fslc+g5fd0b60 (Apr 03 2015 - 18:55:01) CPU: Freescale i.MX6Q rev1.2 at 792 MHz Reset cause: POR Board: MX6-SabreSD I2C: ready DRAM: 1 GiB MMC: FSL_SDHC: 0, FSL_SDHC: 1, FSL_SDHC: 2 *** Warning - bad CRC, using default environment No panel detected: default to Hannstar-XGA Display: Hannstar-XGA (1024x768) In: serial Out: serial Err: serial PMIC: PFUZE100 ID=0x10 Net: FEC [PRIME] Hit any key to stop autoboot: 1 I m stuck up badly. It is not going further. Does the sdcard image contain ΓΌ-boot, kernel image and rootfs ? or should I flash u-boot separately ? I even tried flashing both u-boot and sdcaed image. But getting same messages. Request help in this regard. I'm using Dizzy branch and SABRESD Evk board. Thanks & Regards Shalini K P L&T Technology Services Ltd www.LntTechservices.com<http://www.lnttechservices.com/> This Email may contain confidential or privileged information for the intended recipient (s). If you are not the intended recipient, please do not use or disseminate the information, notify the sender and delete it from your system.
-- _______________________________________________ yocto mailing list yocto@yoctoproject.org https://lists.yoctoproject.org/listinfo/yocto