I'm moving from SW Ohio to the Dallas - Fort Worth area.  I have a storage unit 
and basement full of stuff I can't take and I'm looking for someone that wants 
it.  Hopefully in one big load but if I have to I will piece it out.  There are 
two deadlines - one is impossibly close.  I'm leaving town Friday, so if there 
is ANYBODY that can be here and load things from my basement or the storage 
unit 3 miles away by late Thursday, Sept 21st then I want to hear from you.  
Otherwise anything I don't take will probably be in the storage unit and 
available until late October.  But that will be the hard deadline. After that 
it goes to a scrapper.

An incomplete list of items follows.  There are other spares and miscellaneous 
items that are way too many to list.


        ▪       (2) 42u AlphaServer racks.  36” deep with front and rear doors.
        ▪       DEC RAID Array R7000/R8000 4x6 storage array.  Currently it has 
in it two HSG80 storage controllers and is set up for 1GB FC access.  I have 2 
or 3 HSZ70 controller cards that came in it originally and they worked at the 
time of removal.  However, I'd been told that there is a NVRAM battery on board 
them that if it dies, the controller dies and can't be restored.  Since they 
have been in storage for about 7 years I'd say they were toast (assuming what 
I'd been told was correct).  It has a range of drives in it from 9.1Gb to 18.2 
or maybe 36GB.  Some of my DEC brick drives had died so I opened them up and 
replaced them with Seagate drives of larger capacity.  I have a few extra empty 
containers as well as some extra power supplies.
        ▪       HP EVA3000 - in pieces - No management workstation.
                ⁃       (2) HSV110 Controller
                ⁃       (2) FC-AL hubs
                ⁃       (3) MSA 5314 Fibre storage shelves
                ⁃       (x) 36GB Fibre drives
                ⁃       (x) bus cables, hubs, misc parts.
        ▪       HP MSA1500cs - 4 SCSI modules, 2 FC modules
        ▪       HP MSA1500cs - Unknown configuration - probably 1 SCSI module, 
1 FC module
        ▪       HP MSA20 w/12 750GB LFF drives
        ▪       (3) Compaq 4314 SCSI Dual bus storage shells with 18GB and 36GB 
drives
        ▪       (2) HP DL380 G3 Dual Xeon 2.4Ghz, 4GB RAM, SA6400 RAID, 2GB FC, 
6x36GB SCSI disk
        ▪       HP DL380 G3 Dual Xeon 2.8Ghz, 4GB RAM, SA6400 RAID, 2GB FC, 
6x36GB SCSI disk
        ▪       (2) HP DL360 G3 1-4GB memory, 2 SCSI drives 9.1GB or 18.2GB
        ▪       (2) HP DL360 G1 1-4GB memory, 2 SCSI drives 9.1GB or 18.2GB
        ▪       (2) DEC AlphaServer 800's.  500MHz CPU, I think they have 2GB 
of memory each and a couple 9GB hard drives in the disk slots.  Each has at 
least one SCSI card and a 1GB FC card. I think they have a DEC DE500 or a 
Compaq NC31xx series 100Meg network card.
        ▪       (1) DEC AlphaServer 1200 and (1) DEC Digital Server 5305 Each of these 
has two 500MHz CPUs and also 2GB of memory.  They each have several of the DEC 
StorageWorks disk "bricks" and at least 2 SCSI cards and a 1GB FC card.  They 
also have a DEC DE500 or a Compaq NC31xx series 100Meg network card.  The “white box” 
5305 has NVRAM modified to run OpenVMS
        ▪       DEC Alphastation 255 that won't boot due to a hardware fault.  
Might be memory but I never looked into it.  IIRC, memory for that system was 
tough to come by.
        ▪       DEC/Compaq PWS533 that hasn't been run in a while.  
Configuration unknown.
        ▪       HP ZX2000 is a 1.4GHz system, faster than most out there.  Has 
1GB of memory and I have 2GB here that I never got around to installing.  It's 
got two 250GB IDE drives, 1 IDE CDRom and a Plexor PX-716a SCSI cd burner.  
Currently it's got Windows 2000 server (IA64 version) on it. Theoretically 
OpenVMS can be installed but you need a SCSI card/drives.  I think I bought a 
compatible SCSI card but I never got around to installing it.
        ▪       HP ZX6000 is either a dual 1.3GHz or 1.4GHz system.  Memory is 
unknown but I've got enough around here to put up to 6GB in it.
        ▪       (2) HP RX2600 dual 1.4GHz CPU systems.  Each has at least 4GB 
of memory, 3x36GB SCSI drives, DVD Optical Drive, 2GB FC card and a management 
processor card.
        ▪       Compaq TL891 tape library with two TK89 DLT drives.  Was in 
working condition 8 years ago when replaced with
        ▪       Compaq SSL2020 library with 2 Sony AIT-2 drives  50/100GB 
capacity tapes.  Also was in working condition when it was replaced with
        ▪       Compaq SSL2020 library with 2 Sony AIT-2 drives  50/100GB 
capacity tapes.  About 50 nearly new tape cartridges available. Also was in 
working condition when it was replaced with
        ▪       Compaq MSL5026 with (2) SDLT 1  160/320GB drives.  Drives are 
SCSI. Has NSR1200 FC interface card in library also in working condition when 
replaced with a MSL2024 LTO library.
        ▪       Several Compaq/HP SAN switches.  1 really old Compaq 1GB 
16-port switch, a somewhat newer Compaq 1GB 16-port and 2 HP branded Emulex 
DB32B2 32-port 2GB fabric switches.
        ▪       I have several Compaq Modular Data Routers with LVD or HVD SCSI 
ports, a couple N1200 series Network Storage Routers.
        ▪       I have 3 Microway clones of a DS20E.  667MHz dual CPU. 2GB 
memory, 18 or 36GB hard drive and a CDrom.  I'm keeping at least one for my 
use, maybe one as a spare.  OpenVMS sees them as a DS20E and the regular Alpha 
firmware updates work on them - not that there are any new updates to apply.
        ▪       Various spare parts - SCSI cards,  10MB and 100MB NIC, SCSI 
drives, CD drives
        ▪       (2) SuperMac J700 Macintosh clones - one with a Daystar CPU 
accelerator
        ▪       (1) SuperMac S900 Macintosh clone - with Daystar CPU accelerator

Check out pictures at <https://cincinnati.craigslist.org/sys/6311157435.html>

.

Reply via email to