Did you try to change the requested input and output settings to those that match the USB audio codec ? Change the settings in "options" in the main WSJT area.
On 10/28/07, Brian <[EMAIL PROTECTED]> wrote: > > Hello Andy, thank you for getting back to me. Ok, I think I'm > starting to get the idea. I can't cut and paste the text from the > DOS window, but could certainly post a screen shot of it. But in > summary here is what I've got: > > First I have an error reading wsjt.ini and continuuing with defaults. > Next I have a message ID Interval 10 > This sequence is repeated a second time. > > Then I have a message "Using PortAudio" followed by a table. I am > not sure how this table will come accross in this message but here is > a try: > > Audio Device Input Output Name > 0 2 0 Micorsoft Sound Mapper-Input > 1 2 0 Realtec HD Audio Rear Input > 2 1 0 Modem #2 Line Record > 3 2 0 USB Audio Codec > 4 0 2 Microsoft Sound Mapper Output > 5 0 2 Realtec HD Audio rear output > 6 0 1 Modem #2 Line Playback > 7 0 2 USB Audio CODEC > > Default Input:0 Output:4 > Requested Input:0 Output:0 > Opening devise 0 for input, 4 for output. > Audio streams running normally. > > I need to point out that the Realtec is the internal sound card and > the USB Audio Codec is the SignaLink sound card. > > I hope this will be able to help you point me in the right direction. > > Thank you, > > 73 de KC9HEK > Brian > > --- In digitalradio@yahoogroups.com <digitalradio%40yahoogroups.com>, > "Andrew O'Brien" > <[EMAIL PROTECTED]> wrote: > > > > In the WSJT dos-type window that boots up, what do your device > settings say > > ? > > > > > > > > On 10/28/07, Brian <[EMAIL PROTECTED]> wrote: > > > > > > Good afternoon folks, > > > > > > I have recently downloaded the WSTJ software for use with JT65. I > > > have also read the very well done Bozo's Guide. (Thank you.) That > > > said, I am unable to get the software configured properly. > > > > > > I have been running the more common digital modes for almost two > > > years. I rountinly uses MultiPSK and DM780 using my existing > > > configuration. Basically, I have HRD deluxe connected to my TS- > 2000 > > > on Com Port 1. I have the SignaLink USB connected to the 13 pin > Aux > > > on the TS-2000. In both DM780 and MultiPSK the sound card > inititates > > > the transmit signal. > > > > > > In both of these other softwares, I can also choose which sound > card > > > to use and have identified the SignaLink as the appropriate sound > > > card. > > > > > > When trying to get WSTJ to run, I have gone into my Audio > Properties > > > (Windows XP PRO) and have made the SignaLink my default sound card > > > with no success. > > > > > > I suspect my setup isn't all that uncommon and that I am missing > > > something very simple and obvious. If someone could help me out, > it > > > would be most appreciated. > > > > > > Thank you in advance, > > > > > > 73 de KC9HEK > > > Brian > > > > > > > > > > > > > > > > > -- > > Andy K3UK > > www.obriensweb.com > > (QSL via N2RJ) > > > > > -- Andy K3UK www.obriensweb.com (QSL via N2RJ)
