Ever since having my Flex 3K return from factory service on different problem - and the simultaneous upgrade to PSDR 2.1.5- I have been experiencing a buzzing sound on received signals. The same buzz is on my transmitted signal as well. Sounds almost as if I am running 60 Hz AC on the plates the way some amateurs did in the long ago dark ages of the hobby!
This may occur after the rig/software has been on for only a few minutes . . . or it may not occur for several hours. Switching PSDR off then on again provides immediate, though temporary, relief - but is inconvenient when in QSO mode. The problem is present on both SSB & CW. Anyone else seen this problem? Anyone have a solution? Thanks- Joe, K9OCO _______________________________________________ FlexRadio Systems Mailing List FlexRadio@flex-radio.biz http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz Archives: http://www.mail-archive.com/flexradio%40flex-radio.biz/ Knowledge Base: http://kc.flexradio.com/ Homepage: http://www.flexradio.com/