> On Apr 2, 2015, at 12:45 PM, Tomasz Wlostowski <tomasz.wlostow...@cern.ch> > wrote: > > On 02.04.2015 21:17, Piotr Esden-Tempski wrote: >> Hi Maciek, >> >> I just tested it a bit more. The behaviour of the ratsnest is a bit >> confusing here. Let me describe it with the steps I took and what I >> observed. These are steps on a completely new pcb. >> >> * open pcbnew (leave in default mode) >> * Read netlist >> * Spread out All Footprints (Ratsnest wires are visible) >> * Switch to OpenGL view (Footprints are still visible but no ratsnest >> wires) >> * Move a part around (Ratsnest wires of that particular part appear) >> * Switch back to default view and to OpenGL again (the ratsnest wires >> that were not visible in OpenGL are still invisible and the ones that I >> made appear by moving a part around are still there) >> * Save pcb file and exit pcbnew >> * Reopen pcbnew with the newly created board file >> * Switch to OpenGL view (All ratsnest wires are visible) >> >> Additionally to all that, at the step where I move the parts around in >> the OpenGL mode, additional ratsnest wires are being drawn to the origin >> of the canvas. They are gone after reloading the pcb file. > > Hi Piotr, > > Can you take a screenshot of the last point?^^ > > Cheers, > Tom
Hi Tom, Here you go. :) It is bit difficult to show with a single screenshot, as it changes while dragging parts around. I think it still considers some parts being in the center of the drawing? If you need more information I can try to record a short screencast to illustrate the issue better. :) Cheers, Piotr -- Piotr Esden-Tempski Founder: 1BitSquared
_______________________________________________ Mailing list: https://launchpad.net/~kicad-developers Post to : kicad-developers@lists.launchpad.net Unsubscribe : https://launchpad.net/~kicad-developers More help : https://help.launchpad.net/ListHelp
