> On Apr 2, 2015, at 1:20 PM, Piotr Esden-Tempski <pi...@esden.net> wrote: > > >> On Apr 2, 2015, at 1:16 PM, Piotr Esden-Tempski <pi...@esden.net> wrote: >> >> >>> On Apr 2, 2015, at 12:45 PM, Tomasz Wlostowski <tomasz.wlostow...@cern.ch> >>> wrote: >>> >>> On 02.04.2015 21:17, Piotr Esden-Tempski wrote: >>>> Hi Maciek, >>>> >>>> I just tested it a bit more. The behaviour of the ratsnest is a bit >>>> confusing here. Let me describe it with the steps I took and what I >>>> observed. These are steps on a completely new pcb. >>>> >>>> * open pcbnew (leave in default mode) >>>> * Read netlist >>>> * Spread out All Footprints (Ratsnest wires are visible) >>>> * Switch to OpenGL view (Footprints are still visible but no ratsnest >>>> wires) >>>> * Move a part around (Ratsnest wires of that particular part appear) >>>> * Switch back to default view and to OpenGL again (the ratsnest wires >>>> that were not visible in OpenGL are still invisible and the ones that I >>>> made appear by moving a part around are still there) >>>> * Save pcb file and exit pcbnew >>>> * Reopen pcbnew with the newly created board file >>>> * Switch to OpenGL view (All ratsnest wires are visible) >>>> >>>> Additionally to all that, at the step where I move the parts around in >>>> the OpenGL mode, additional ratsnest wires are being drawn to the origin >>>> of the canvas. They are gone after reloading the pcb file. >>> >>> Hi Piotr, >>> >>> Can you take a screenshot of the last point?^^ >>> >>> Cheers, >>> Tom >> >> Hi Tom, >> >> Here you go. :) >> >> It is bit difficult to show with a single screenshot, as it changes while >> dragging parts around. I think it still considers some parts being in the >> center of the drawing? If you need more information I can try to record a >> short screencast to illustrate the issue better. :) > > One more thing. I just realized, it is not the origin. It is the position > where the parts were before I used the spread function…
Again, just as a data point, I am seeing exactly what Piotr is seeing. -a _______________________________________________ Mailing list: https://launchpad.net/~kicad-developers Post to : kicad-developers@lists.launchpad.net Unsubscribe : https://launchpad.net/~kicad-developers More help : https://help.launchpad.net/ListHelp