In order to configure the listener port on the HP you should do something like:
openflow <vlan> listener ptcp:<port> Then you should be able to dpctl the switch. Though a word of warning, now everyone else can too :P . Aaron On Tue, Feb 28, 2012 at 7:05 PM, Murphy McCauley <jam...@nau.edu> wrote: > This sounds like a switch configuration issue; you might try whatever support > channels HP provides. > > Is NOX configured to listen for connections on whatever port you set the > switches to connect to? > > -- Murphy > > On Feb 28, 2012, at 3:36 PM, Elias Marti Paz-Rudolph wrote: > >> I am using HP ProCurve 3500 yl switches. i have configured the switch to >> listen on port 6633. >> I am using ipv4 addresses. I also configured the switch to point to my nox >> controller. I was using dpctl to see if the switches connect and they dont. >> I am using Ubuntu to run NOX >> >> --Elias >> On Feb 28, 2012, at 4:25 PM, Murphy McCauley <jam...@nau.edu> wrote: >> >> "OpenFlow version 2.02" doesn't mean anything to me. What kind of switches >> are you using? >> >> What IP address are you using with dpctl? The switch? In general, switches >> make active connections (they initiate a connection to the controller/NOX), >> so it's not listening on port 6633. Sometimes switches can also be >> configured to listen too, but it depends on the switch and on the >> configuration. >> >> More to the point, you say that you're trying to get NOX to send messages to >> the switch, but dpctl doesn't have anything to do with that. Have you >> configured the switches to connect to the IP that you're running NOX on? If >> you run NOX and set it to listen for connections, do the switches connect? >> What commandline are you running NOX with? >> >> -- Murphy >> >> On Feb 28, 2012, at 3:11 PM, Elias Marti Paz-Rudolph wrote: >> >> >> >> Hello, >> I am in the beginning stages of implementing an OpenFlow network. I believe >> i have configured my switch correctly. I am trying to get NOX to send >> messages to the switch. >> When i send >> >> dpctl dump-tables tcp:xxx.xx.xx.xxx:6633 >> >> i get a connection refused message back. >> >> I am using NOX version 0.9.0 >> >> and OpenFlow version 2.02 >> >> Can you help me this is? >> >> Thanks >> Elias >> >> >> >> >> Elias Paz >> CompE Undergraduate >> member of HESO >> Hispanic Engineering and >> Science Organization(SHPE/MAES) >> nmeli...@unm.edu >> (505) 550-9554 >> _______________________________________________ >> nox-dev mailing list >> nox-dev@noxrepo.org >> http://noxrepo.org/mailman/listinfo/nox-dev > > _______________________________________________ > nox-dev mailing list > nox-dev@noxrepo.org > http://noxrepo.org/mailman/listinfo/nox-dev -- Aaron O. Rosen Masters Student - Network Communication 306B Fluor Daniel _______________________________________________ nox-dev mailing list nox-dev@noxrepo.org http://noxrepo.org/mailman/listinfo/nox-dev
