Hello, We need some help with our Disaster Recovery scenario. We have two Network Storage Managers, model C01, with TSM Server for AIX V4.1 and DRM licensed, both attached to their own IBM 3494 ATL. Our goal is to achieve DR without manual tape-handling, so all data must be send across the wire.
This is what we did: * Installed a special DISKPOOL for Client Nodes that are willing to pay for DR * Defined device class devtype=server servername=targetserver on the source server * Defined source server type=server and a special policy domain and storage pool on the target server * Copied the primary DISKPOOL (on the source) to the COPYPOOL (on the target) succesfully * Checked that the Virtual Volumes contains DR data Until here no surprises, just plain DRM functionality But now what we wish to do: * One single Client Node died at the primary site * The responsible department has rebuilt that Client Node at the DR site and asked us to restore the data * We tried to make the target server aware to restore the data at his site, but were unable to make it work So what's the challenge: * Is there a way to rebuild individual Client Nodes at the DR site without (additional) tape transport? Any help is appreciated. With regards, Ray Kramer & Hans van den Hoven, Rabobank ICT Storage Management Group The Netherlands Mailto:[EMAIL PROTECTED] Mailto:[EMAIL PROTECTED] ================================================ De informatie opgenomen in dit bericht kan vertrouwelijk zijn en is uitsluitend bestemd voor de geadresseerde. Indien u dit bericht onterecht ontvangt, wordt u verzocht de inhoud niet te gebruiken en de afzender direct te informeren door het bericht te retourneren. ================================================ The information contained in this message may be confidential and is intended to be exclusively for the addressee. Should you receive this message unintentionally, please do not use the contents herein and notify the sender immediately by return e-mail.