I don't know how to explain the causes, but a reset on the drive worked for me.. :)
On 11/30/05, Gerald <[EMAIL PROTECTED]> wrote: > Bingo! > > I thought i'd checked all the ends but when I went to remove the short > cable daisy-chaining the one good drive to the one bad drive, I found > a bent pin on the end of the cable I had not previously checked. I was > removing it because the first device was working in the chain and the > second was not. Perhaps the cable itself was bad I thought. Turns out > it was just a bent pin.. > > Gerald > > On 11/29/05, Bob Booth - UIUC <[EMAIL PROTECTED]> wrote: > > On Tue, Nov 29, 2005 at 05:27:10PM -0800, Gerald wrote: > > > I have a drive that from AIX lists as available. In TSM when i try to > > > > > > define a path to the drive I get an "ANR8420E DEFINE PATH: An I/O > > > > > > error occured while accessing drive DRIVE1." and a "ANS8001I Return > > > > > > code 15.". Then below is what appears in the AIX error report. > > > > Has this drive ever worked? If it has been de-cabled, or the lead drive > > has been removed, check the cables again. Make very sure that NONE of the > > pins are crossed over. If any of the ground lines are crossed, or not > > making contact, the drive may register (become available), but you won't be > > able to do anything with it. Check the terminators as well, and any place > > where the cable may have been disconnected. Those cables are very easy to > > bend pins on! > > > > If it was functioning and quit, and has not been disconnected, you may have > > a problem in the interface card pack on the drive. Also make sure that > > the interface you are connected to on the drive says it is online on the > > front panel. You can also rmdev the drive and do a mkdev on it to see if > > it comes back. > > > > If all else fails, have your CE run a SCSI wrap test after running card > > diags on the drive. > > > > just some thoughts. > > > > bob > > > > > -- > -Gerald > -- Helder Garcia