I had this issue once. I dont recall an RMA. It probably ended up deployed again close by in case of further issue then forgot about. I do remember loading multiple firmwares in both banks multiple times to make sure nothing collapsed
On Thu, Dec 21, 2023 at 4:55 PM Nate Burke <n...@blastcomm.com> wrote: > I had an EPMP3000 AP on a tower that died after a web page initiated > reboot. I got it swapped out and when I put it on the bench, accessing > on 169.254.1.1 loaded a page saying to 'Load Firmware' With a big > disclaimer saying 'No Firmware validation done, make sure you load a > proper image' > > I loaded the 4.6.1 firmware on it, and it appears to be booting normally > now. I'm concerned to deploy it again, since 'something' happened, but > why wouldn't it have loaded the backup firmware if the primary was > corrupted? Anyone run into this before? The AP was acting up which is > what prompted the initial reboot. 2 Sm's next to each other on a roof, > one SM had 70% packet loss, the Other SM had 0% packet loss. Only thing > that hadn't been rebooted yet was the AP. > > > -- > AF mailing list > AF@af.afmug.com > http://af.afmug.com/mailman/listinfo/af_af.afmug.com >
-- AF mailing list AF@af.afmug.com http://af.afmug.com/mailman/listinfo/af_af.afmug.com
