Do you have the radios something like 20ft of vertical separation to
make this work? if they are too close together wouldn't the tx interfere
with the rx of the link next to it shooting the same direction?
Matthew Jenkins
SmarterBroadband
m...@sbbinc.net
530.272.4000
On 10/13/2014 11:58 PM, Josh Reynolds via Af wrote:
That's incorrect. You have "link 1" on one set of freqs, then on "link
2" you swap the TX/RX freqs.
We have a site with 5 AF24s on it currently. No problems.
Josh Reynolds, Chief Information Officer
SPITwSPOTS, www.spitwspots.com <http://www.spitwspots.com>
On 10/13/2014 05:49 PM, Eric Kuhnke via Af wrote:
No you can't, in 750Mbps mode an af24 link takes all available 24 GHz
bandwidth in both polarities. Will not work in parallel ptp between
the same two sites. Will work if one af24 is aimed off-azimuth at
least 10 degrees at another third site.
On Oct 13, 2014 4:48 PM, "Jerry Richardson via Af" <af@afmug.com
<mailto:af@afmug.com>> wrote:
1 Gig both ways?
You **could** theoretically use two AF24’s and a Mikrotik router
to bond the connections.
This would give them <1.0Gbps with redundancy.
*From:*Af [mailto:af-boun...@afmug.com
<mailto:af-boun...@afmug.com>] *On Behalf Of *TJ Trout via Af
*Sent:* Monday, October 13, 2014 3:59 PM
*To:* af@afmug.com <mailto:af@afmug.com>
*Subject:* [AFMUG] Cheapest way to bachaul 1gig fiber 1 mile?
What is the cheapest method of backhauling a 1gig fiber about 1
mile? I'm assuming you can't reliably bond or aggregate airfiber
24's can you?
TJ
