Nope, it's almost always random. You can set the serials in the order
you want, then just issue a rescan.. move on with life.
On 10/17/2014 12:25 PM, That One Guy via Af wrote:
ok, so now a new question
I removed the devices
set to 0, cleared them
Then when I reconnected base unit-syncinjector-UPS
its showing the index order as base unit-UPS-syncinjector
Does it not go in the physical order they are connected?
On Fri, Oct 17, 2014 at 12:21 PM, That One Guy via Af <af@afmug.com
<mailto:af@afmug.com>> wrote:
Jesus H Kittens
My power supply was not connected, I didnt even think to look at
that since the light was on, apparently that light is powered
through the serial cable. Im a dumbass
On Fri, Oct 17, 2014 at 12:17 PM, George Skorup (Cyber
Broadcasting) via Af <af@afmug.com <mailto:af@afmug.com>> wrote:
6 flashes and the SyncPipe wouldn't power up means you didn't
have the power input to the SyncInjector connected, or no
power to it.
The SyncInjector will either power its expansion bus by itself
(if it has power on the input block) or it will take power
from the base unit. That's why you could see it connected to
the base, but it obviously needs its own power connected to
power up radios and the SyncPipe.
As everyone else has already said, to remove an expansion
unit, just go into the expansion tab and set the device's
serial to zero. Power down the base and physically remove the
expansion unit from the bus. You should not be hot-plugging
anything on the expansion bus. Forrest said it probably won't
hurt anything, but just don't do it.
On 10/17/2014 11:19 AM, That One Guy via Af wrote:
I remember somebody asking this once before
How do you clear a device from a base unit. We were testing a
syncinjector then removed it and started testing a UPS
moniter, but the base unit still shows the syninjector, we
have powercycled, we have rescanned, still there.
Also we have a syncpipe that when connected to the
syncinjector does not light up, the syncinjector ports green
light just keeps flashing 6 times
Is there a better set of instructions somewhere for using
this gear, the stuff on the packetflux website isnt complete
or clear, maybe im just not looking in the right spot?
--
All parts should go together without forcing. You must
remember that the parts you are reassembling were
disassembled by you. Therefore, if you can't get them
together again, there must be a reason. By all means, do not
use a hammer. -- IBM maintenance manual, 1925
--
All parts should go together without forcing. You must remember
that the parts you are reassembling were disassembled by you.
Therefore, if you can't get them together again, there must be a
reason. By all means, do not use a hammer. -- IBM maintenance
manual, 1925
--
All parts should go together without forcing. You must remember that
the parts you are reassembling were disassembled by you. Therefore, if
you can't get them together again, there must be a reason. By all
means, do not use a hammer. -- IBM maintenance manual, 1925
