Not a problem. They should run fine on 56v actually.
Josh Reynolds, Chief Information Officer
SPITwSPOTS, www.spitwspots.com <http://www.spitwspots.com>
On 10/21/2014 10:17 AM, That One Guy via Af wrote:
Will it hurt the TI to be running off 50v rather than 48?
We have a M5TI thats freaking out every night, poor throughput though
it shows a good link, high latency, etc. Its getting replaced with a
650 but Im curious if its possible the unit is getting an overvoltage
We had to flip flop AP station, when it was AP it would lock up the
link, the Station would still show connected, I would have to reboot
the station to force it to establish a new link.
It is high interference, so that probably it too.
On Tue, Oct 21, 2014 at 12:21 PM, Mathew Howard via Af <af@afmug.com
<mailto:af@afmug.com>> wrote:
I have one from a RocketM2 Ti here... it's a UBI-POE-48-5G. pinout
is the same, but it's only 48v vs 50v. I suspect it would work
fine, but the voltage is a bit higher, so I suppose there's some
risk of letting magic smoke out.
------------------------------------------------------------------------
*From:* Af [af-boun...@afmug.com <mailto:af-boun...@afmug.com>] on
behalf of That One Guy via Af [af@afmug.com <mailto:af@afmug.com>]
*Sent:* Tuesday, October 21, 2014 11:14 AM
*To:* af@afmug.com <mailto:af@afmug.com>
*Subject:* [AFMUG] AF24 power supply for Rocket M5 TI
I have a box of GP-C500-120G power Supplies for air fiber,
+(1,2)(4,5) -(7,8)(3,6) 50V
Im trying to figure out which power supply is the actual one for
M5 TI and if theyre compatible
--
All parts should go together without forcing. You must remember
that the parts you are reassembling were disassembled by you.
Therefore, if you can't get them together again, there must be a
reason. By all means, do not use a hammer. -- IBM maintenance
manual, 1925
--
All parts should go together without forcing. You must remember that
the parts you are reassembling were disassembled by you. Therefore, if
you can't get them together again, there must be a reason. By all
means, do not use a hammer. -- IBM maintenance manual, 1925
