The dragonwave is an older HC. It does not have the capability to use port 2 as a data port. Unlike the HC+.
On Tue, Apr 14, 2015 at 5:31 PM, Duncan Scott <[email protected]> wrote: > Can the Dragonwave use mulitple ethernet ports as separate bridges? If > you can configure separate bridge ports you might be able to set up an 4 > channel etherchannel and direct 2 over the 600 meg link and 1 on each of > the 300 meg links. > > On 4/14/2015 3:23 PM, Sam Lambie wrote: > > We currently have a Dragonwave Dual Mounted 2+0 PTP setup that is Ether > > channeled with Cisco switches. Currently each radio link is at 300 mbps. > > Easy to Ether channel as they are the same sized pipe. Once you get into > > links of differing throughput, then Ether Channel will fill up to the > > smallest pipe and the rest is wasted. > > In the the next month, we are going to install another 2+0 link in the > same > > direction that should have up to 1.2 gb aggregate on that link alone. And > > 600 mbps on the DW link. So my question is how to essentially bond both > > links of differing sizes without wasting wireless throughput. Is there > > something better than Ether channel? > > > > > > > > > > -- -- *Sam Lambie* Taosnet Wireless Tech. 575-758-7598 Office www.Taosnet.com <http://www.newmex.com>
