Set up a roadside squirrel stand like the squirrel lady in the movie “Rat Race”.

“You should have bought a squirrel.”


From: David Milholen 
Sent: Monday, May 11, 2015 6:48 AM
To: [email protected] 
Subject: Re: [AFMUG] Voltage\Amperage on Shielded Cable

make a large funnel with a deep enclosure for the funnel to fit on top of so 
the base of the funnel is inside the drum/enclosure.
place some peanut butter in the base of the drum and coat the inside of the 
funnel with teflon oh and yes be sure the 
base of the funnel has a large enough hole big enough to allow them to get in 
and it must have a neck on the funnel.
Give them  a  plank to walk over the funnel. 
This way the little suckers will fall into the drum and if its deep enough cant 
get out.
Or you could get some of the larger rodent traps at farm supply that do the 
same thing accept they lay flat on the ground 
I dont like catching the big ones that are larger than the trap cuz they get a 
little angry.



On 5/10/2015 11:22 PM, Mike Hammett wrote:

  I think I'm going to set out some live traps tomorrow and relocate them. I 
guess the farmer hates the squirrels being there, soooo....  now they won't be.




  -----
  Mike Hammett
  Intelligent Computing Solutions
  http://www.ics-il.com



  Midwest Internet Exchange
  http://www.midwest-ix.com




------------------------------------------------------------------------------

  From: "Mathew Howard" mailto:[email protected]
  To: "af" mailto:[email protected]
  Sent: Sunday, May 10, 2015 11:19:07 PM
  Subject: Re: [AFMUG] Voltage\Amperage on Shielded Cable


  Conduit would probably be the most practical fix, but shooting the little 
vermin would be so much more satisfying...


  On Sun, May 10, 2015 at 4:40 PM, Mike Hammett <[email protected]> wrote:

    I don't even know what you're saying anymore. You said to run conduit. I 
said it would be expensive and complicated, but agreed. You then said conduit 
would be cheaper in the long run as if I disagreed (when I didn't). I confirmed 
that I agreed. You kept posting as if I was disagreeing with you, but I'm not.




    -----
    Mike Hammett
    Intelligent Computing Solutions
    http://www.ics-il.com



    Midwest Internet Exchange
    http://www.midwest-ix.com




----------------------------------------------------------------------------

    From: "Sean Heskett" <[email protected]>
    To: [email protected]
    Sent: Sunday, May 10, 2015 4:36:20 PM
    Subject: Re: [AFMUG] Voltage\Amperage on Shielded Cable

    Not if you count labor and opportunity cost it isn't 


    On Sunday, May 10, 2015, Mike Hammett <[email protected]> wrote:

      I did say it would be cheaper to run conduit than to keep running cable.

      http://www.cheaperthandirt.com/ProductListing.aspx?catid=104

      
http://www.sportsmansguide.com/productlist/ammo-shooting/rifle-ammo/22lr-ammo?d=121&c=96&s=2886




      -----
      Mike Hammett
      Intelligent Computing Solutions
      http://www.ics-il.com



      Midwest Internet Exchange
      http://www.midwest-ix.com




--------------------------------------------------------------------------

      From: "Sean Heskett" <[email protected]>
      To: [email protected]
      Sent: Sunday, May 10, 2015 4:12:06 PM
      Subject: Re: [AFMUG] Voltage\Amperage on Shielded Cable

      Depend on if you want a bigger CAPEX or a bigger OPEX  

      I prefer a bigger capital expense and a smaller operating expense.  I 
don't like visiting POPs over and over to fix stuff.

      2 cents

      -Sean


      On Sunday, May 10, 2015, Mike Hammett <[email protected]> wrote:

        That sounds expensive and complicated, though less so than running new 
wires all of the time. TBH, I'd rather just sit there and shoot them all than 
run conduit up the grain leg.




        -----
        Mike Hammett
        Intelligent Computing Solutions
        http://www.ics-il.com



        Midwest Internet Exchange
        http://www.midwest-ix.com




------------------------------------------------------------------------

        From: "Sean Heskett" <[email protected]>
        To: [email protected]
        Sent: Sunday, May 10, 2015 3:37:49 PM
        Subject: Re: [AFMUG] Voltage\Amperage on Shielded Cable

        I'd run the cable thru liquidtight conduit. 



        On Sunday, May 10, 2015, Mike Hammett <[email protected]> wrote:

          How much voltage\amperage on the cable's shield could the radio 
handle without messing up? Since these squirrels like chewing cables, I'd like 
to give them a shocking experience! Hook a cheap fence charger to the ground 
wire of the SS chassis?  ;-)

          Note: I don't actually intend on doing that...  not because of the 
squirrels, but because I don't wanna jack up the radios.




          -----
          Mike Hammett
          Intelligent Computing Solutions
          http://www.ics-il.com



          Midwest Internet Exchange
          http://www.midwest-ix.com










-- 

Reply via email to