That's very confusing. If all of the power levels are nearly the same,
how can the ratio be that far off? That makes no sense. Unless it
doesn't mean the same thing as with SSR on the PMP450 (V-H or B-A Rx
power ratio).
On 9/9/2015 11:01 AM, Josh Luthman wrote:
I was thinking signal vs noise. Like SNR.
Seems impressive to know there's a cable issue when the signals are
the same.
Josh Luthman
Office: 937-552-2340
Direct: 937-552-2343
1100 Wayne St
Suite 1337
Troy, OH 45373
On Sep 9, 2015 11:55 AM, "SmarterBroadband"
<li...@smarterbroadband.com <mailto:li...@smarterbroadband.com>> wrote:
Just a noise issue? The manual says;
Signal Strength Ratio is an aid to debugging a link. If it has a
large positive or negative value then investigate the following
potential problems:
• An antenna coaxial lead may be disconnected.
• When spatial diversity is employed, the antenna with the lower
value may be pointing in the wrong direction.
• When a dual polar antenna is deployed, the antenna may be
directed using a side lobe rather than the main lobe.
I was thinking bad cable? Maybe antenna or radio.
*From:*Af [mailto:af-boun...@afmug.com
<mailto:af-boun...@afmug.com>] *On Behalf Of *Josh Luthman
*Sent:* Wednesday, September 09, 2015 8:40 AM
*To:* af@afmug.com <mailto:af@afmug.com>
*Subject:* Re: [AFMUG] PTP650 Issue
Noise at the one end. The other has 20 with the same signal.
Josh Luthman
Office: 937-552-2340 <tel:937-552-2340>
Direct: 937-552-2343 <tel:937-552-2343>
1100 Wayne St
Suite 1337
Troy, OH 45373
On Sep 9, 2015 11:36 AM, "SmarterBroadband"
<li...@smarterbroadband.com <mailto:li...@smarterbroadband.com>>
wrote:
We have an issue with one of our PTP650 links. Bad Signal
Strength Ratio.
One end is 6.4 the other 19.5
Issue is probably at one end.
Question is which end to check first.
I have attached the System Stats of each end.
Anyone able to see which end may have the problem from these?
Thanks
Adam
