Would it be cheaper to have N connectors or jumpers? Keep in mind the N are on top of the SM.
Josh Luthman Office: 937-552-2340 Direct: 937-552-2343 1100 Wayne St Suite 1337 Troy, OH 45373 On Jan 14, 2016 8:40 PM, "Chuck McCown" <ch...@wbmfg.com> wrote: > Possibly. I have the mold for the cover. Back would be aluminum. Just > need a nice pocket that slips over and interfaces with the radio. Does > the radio come with cables? > > *From:* Josh Luthman <j...@imaginenetworksllc.com> > *Sent:* Thursday, January 14, 2016 6:33 PM > *To:* af@afmug.com > *Subject:* Re: [AFMUG] 900mhz PMP450i with dual polarity panel > > > Slip on stinger would be way faster. Could you match the price? > > Josh Luthman > Office: 937-552-2340 > Direct: 937-552-2343 > 1100 Wayne St > Suite 1337 > Troy, OH 45373 > On Jan 14, 2016 8:31 PM, "Chuck McCown" <ch...@wbmfg.com> wrote: > >> I would have to have a large commitment to meet that price for a slip on >> stinger version. >> >> *From:* Mathew Howard <mhoward...@gmail.com> >> *Sent:* Thursday, January 14, 2016 5:58 PM >> *To:* af <af@afmug.com> >> *Subject:* Re: [AFMUG] 900mhz PMP450i with dual polarity panel >> >> This is the antenna: http://www.lanbowan.com/ANT915D12C-DP.htm >> >> The antennas themselves are pretty cheap - they charged me $41.61/each, >> but shipping was quite expensive (they sent them DHL - there are obviously >> cheaper ways). I suspect that if you ordered a large enough quantity to get >> a decent shipping rate, even after adding jumper cables, it would still be >> a bit cheaper than the Cambium yagis. >> >> I did do a little testing with V/H... but it was kind of inconclusive, >> the signal level was only slightly weaker, but when I ran a link test, it >> was much worse - about 45m down vs 90m, I tried holding the Cambium yagi at >> a 45 degree angle and it was pretty similar results - 70m vs 90m and >> slightly weaker signal. I'm not sure if that was anything to do with the >> polarity being mismatched, or if it was just that H/V doesn't work as well >> as slant at that particular location... also, I was just holding thing >> antennas for the H/V tests and they were mounted at +/-45, so that could >> account for some of it too. >> >> On Thu, Jan 14, 2016 at 4:50 PM, Chuck McCown <ch...@wbmfg.com> wrote: >> >>> What’s it cost? >>> >>> *From:* Mathew Howard <mhoward...@gmail.com> >>> *Sent:* Thursday, January 14, 2016 3:36 PM >>> *To:* af <af@afmug.com> >>> *Subject:* [AFMUG] 900mhz PMP450i with dual polarity panel >>> >>> Fresh from China :) >>> >>> I tested it at two different customer's houses, and signal levels were >>> consistently within 1db of the Cambium yagis. Not quite as clean of a >>> package as the Cambium antennas, but it works and it's not a yagi... I did >>> have to replace the bracket to make it dual slant though. >>> >> >> >