We just released a new beta load for R13.4.1. There are a ton of bug fixes and stability improvements, and this is a release candidate for the final software release for these products. We would really appreciate anyone interested to go download this and run it through its paces, especially if you’ve had any issues.
NOTE: This is NOT for 450 platform devices (we’re working on an update to R14.1.2, which is coming next). Software can be found here: https://support.cambiumnetworks.com/files/pmp100/beta Forum discussion for this is here: http://community.cambiumnetworks.com/t5/PMP-Beta/Beta-Software-13-4-1-Build14-for-PMP100-PTP100-PMP430-and-PTP230/m-p/49839 Brief Release Notes (copied here for your convenience): 13.4.1 (Build 14) has the following improvements and fixes: • Fixed an issue where AP resets after a user logs in, when Authentication is set to “Remote” or “Remote then Local” and Accounting is enabled without configuring all three Accounting servers. • whispGPSInSync and whispGPSOutSync traps are repeatedly sent out when the radio loses sync • Config file: Shared secret of RADIUS server does not export correctly • Unable to ping from the telnet interface of an SM in NAT mode to a PC connected to it on its LAN interface Enhancements: • Configurable option to allow ICC connected SM to use the AP’s Mgmt VID instead of the SM’s own Mgmt VID • Updates to Event Logs for Radio Reset Cause • Display IP of the RADIUS Authentication Server of each SM on the Session Status list • “Aiming” page (previously Alignment Tab). The Aiming page is similar to spectrum analyzer where the SM will scan and list all scanned APs on its page (and the AP Evaluation page) but will not come into session with any APs. Two modes of operation are supported: o Single Frequency Only: The SM will scan only the configured frequency and list all scanned APs o Normal Frequency Scan List: The SM will scan all checked frequencies and list all scanned APs Fixes and enhancements included in previous 13.4.1 beta release builds: Defect Fixes: • SNMP OID GetChanBandWidthFlash returns the correct Chanel Bandwidth for SMs • NAT Port Mapping now works properly with Configuration File • Memory corruption that may occur when using RADIUS • Importing/exporting of the Authentication Key now works properly with Configuration File • 900MHz FSK and OFDM frame alignment fixes • P8 radios now correctly load 13.4.1 • Fix bug where DHCP Option 81 is incorrectly populated • Fixed “varbind error” in CNUT Enhancements: • GUI Option for FreeRun to work at boot up • Minor Configuration File changes • Trap for GPS Sync loss will now be sent if the radio is rebooted. • Interference Stats now available on the SM • Update to the reboot message in the event log caused by CNUT • Syslog Improvements • Disconnect and Stop messages are now supported in RADIUS • Jitter Stats now available on PMP 100 SMs