If you attempted to attach a picture it didn't make it to the list I don't
think.

On Fri, Feb 26, 2016 at 8:31 PM, Sterling Jacobson <[email protected]>
wrote:

> I can't for the life of me figure this out.
>
> I have two CCR routers running OSPF/MPLS/VPLS between them.
>
> There is traffic flowing between them from two different VPLS tunnels.
>
> Occasionally, as shown in the graph, just one of them (same one every
> time) will throttle to 35Mbps download.
>
> Sometimes it recovers on its own after a few minutes, or over an hour.
>
> IF I go into the CCR INSIDE that tunnel (IP addresses inside the tunnel on
> both sides) and start a TCP bandwidth test between them, I get 900+Mbps and
> it magically fixes the problem every time.
>
> The only difference between the two tunnels I can tell, is the problem one
> is routing a block to an end router outside the tunnel on that port with a
> connected IP, and the other is a direct block routing to gateway on the
> edge CCR.
>
> Explain that one to me!
>
>
>

Reply via email to